![]() When scorch or burn stains occur, weigh the odds before tackling the problem. When using caustic, toxic, aromatic or flammable cleaning solutions, be certain to provide for adequate venti lation.Rub the area briskly with a mixture of rottenstone and a few drops of boiled linseed oil or lemon oil. Rub lightly until the scratch is even with the finish. To complete treatment, sand off the surface using very fine sandpaper (8/0) or the fine side of an emery board. Scrape it across the surface making sure not to burn the finish surrounding the repaired area. To level off the area, heat the blade again and wipe it clean. Repeat the process until the area is filled. Scrape off a small piece and press it into the blemish using the edge of the spatula blade. Heat a knife blade over an electric range surface unit until the blade is just hot enough to melt the shellac. Fill the dent with lacquer stick (available from furniture store) in a color to match the finish. Smooth with fine steel wool (#0000) wrapped around the top of an orange stick. Clean area with cotton swab dampened with naphtha. Remove charred material using a sharp knife or razor blade.Hand rubbing with a felt pad helps blend in the repaired section. Apply stain if needed to blend with the original color, then restore the finish coating, whether of lacquer, varnish or rubbing oil. To restore the natural oils of the wood, rub in linseed oil or a clear mineral oil. When all stain is removed, sponge with clear water. If any brown stain remains, apply a chlorine laundry bleach to a cotton swab and place on stain, allowing time for bleaching to occur. Sometimes a light scorch or cigarette burn can be removed by rubbing the browned area with superfine (#0000) steel wool.When using caustic, toxic, aromatic or flammable cleaning solutions, be certain to provide for adequate ventilation.Be sure to store and dispose of products!cans/containers as recommended.The removal process includes sanding and bleaching – both of which can damage or even remove the existing finish. When scorch or burn stains occur on wood floors, proceed with extreme caution in removing them.Condition the wood and restore the finish as stated in Method #1 above. When all scorch (0 much as you think will bleach out is removed), neutralize the acid by applying borax powder to the sta Sponge with clear water and allow to dry. and allow to remain until the scorch is bleached. Depending on the size of the stained area, apply the acid solution to a cotton swab, cotton ball, folded absorbent cloth, etc. If burned area is dark and heavy, make a solution of 1 tablespoon oxalic acid crystals and 1 cup warm water.Apply stain if needed to blend with the original color, then restore the finish coating, whether of shellac, varnish or rubbing oil. Hard Surface Floors Wood (Oiled, Stained, Varnished, Waxed) If necessary, follow with a cleaning treatment, using a commercial household cleaner such as 409, Fantastic, etc. Then lightly sand the edges of the burn with coarse sandpaper and vacuum again. Minor burns can be treated by vacuuming first with a long nozzle to generate high suction. If the scorch or cigarette burn is severe, you will have to contact a a professional to repair the carpet. Be sure to store and dispose of products/cans/containers as recommended.Always pretest each cleaning agent on an inconspicuous area first to determine colorfastness.Be careful any time a commercial product or combination of cleaning supplies are used.Do not use any products or procedures prohibited by the care label. Always read the care label before trying any stain removal method.Wet with lemon juice and spread in the sun to dry. ![]() Otherwise, soak in sodium perborate bleach and hot water, then launder. Wash using laundry detergent, hot water and chlorine bleach, if safe for fabric.Cover with a dry cloth and press with iron as hot as safe for fabric. For heavy stain, cover with a cloth dampened with 3 percent hydrogen peroxide. For light scorch, wet the stain with 3 percent hydrogen peroxide.
0 Comments
Leave a Reply. |